About Us
People
Centre Personnel
Investigators
Chief investigators
Partner investigators
Affiliate investigators
Research Staff
Postdoctoral Fellows
PhD Students
Visiting Researchers
Facilities
UNSW
ANU
Computed Tomography Lab
Nanotechnology Lab
TUM
Projects
Gallery
PhD Projects
Dental-Composites
Durability of Composite Propellers
Advanced Manufacturing Growth Centre
Publications
Journal
Publications
Conference Proceedings
Workshops
PhD Thesis
Get involved
Contact Us
Accessories
April 3, 2018
Published by
alidarejeh
at
April 3, 2018
Categories
I have prepared two 2D drawings for roller core & elastomer (attached) and we are going to make them here, I would be really grateful if I have your comments on that?
Typically, we will have the elastomer molded onto the core rather than using tube or such stretched over the core. I am not certain that is
[…]
April 3, 2018
Published by
alidarejeh
at
April 3, 2018
Categories
What is the acceptable hardness & thickness for the elastomer (urethane/silicone)? I measured the hardness of the tow rollers that we have, one of them is around 40-45 & the other one is around 60-66. So, what would be the best range if we want to make new roller with smaller size?
The material type and hardness is really up to you. We have used both urethane and silicone for compaction rollers, and we also use a range
[…]
March 16, 2018
Published by
alidarejeh
at
March 16, 2018
Categories
I tried adjusting the torch as per Michael’s instructions after manufacturing the tools that he had suggested and the torch is still not working. Do we need to purchase a new torch from ADC?
Well, OK that was the first round of trials and questions about the torch operation. There is a little red indicator light on the front of
[…]